Receiver/Amplifier cooling fan w/Super air-chamber base/multi-speed control

Description

Super Mega-fan Cooling system with huge Air-chamber base
This cooling fan system sits on your component's top air vents.
It has a special raised air-chamber base, which covers over 50 square inches of your component's top vents.
Air is pulled from your component over the full area of this large raised base.
You will feel a steady stream of warm air as the fan pulls the hot air out of the casing, and at the same time creating a vortex of cooling air inside your unit, pulling air up from the bottom vents.
In addition, you control the speed of the fan, with the multi-voltage power transformer.
Plug the power unit into a switched AC outlet on your system, and the fans will only come on when the equipment is turned on or the switch is activated.
What's
Included?
THE COOLING SYSTEM INCLUDES:
1 x 120mm Superbase fan unit
,  1 x multi-speed power transformer, and printed installation instructions.
Note:   In the listing pictures, the component cooling systems are shown in two views:  1) On top of a receiver or other component to show how it is used and 2) against a colored panel, displaying the complete system.
These components and panels are used for display purposes only, and are not included with the system.
1 x 120mm
component-top
fan unit, with a
7.5" x 7.5"
Air-chamber base
(covers over 50
square inches of
your component's
top vents
).
1 x multi-speed
power transformer,
with a 4-1/2 foot
cable.  You can
choose from 6
different speeds
for the fan.
Features
This cooling system has a high-quality, low-noise 120mm fan, with long-lasting and quiet fluid dynamic bearings.
The fan unit has a specially-constructed raised air-chamber base that enlarges the area of airflow, while also sealing air and preventing vibrations.
This base covers over 50 square inches -- it measures 7.5" x 7.5".
Don't worry if your air vents are smaller (or larger) than the air-chamber base -- it is designed to adapt to any size vents.
Includes a multi-speed power transformer, which plugs into any 120 volt outlet.  You control the speed of the fan, using this multi-speed transformer, which can be set to any one of 6 different speeds.
Plug the power unit into a switched AC outlet on your system, and the fans will only come on when the equipment is turned on or the switch is activated.
INTERNATIONAL BUYERS:
The unit's power transformer (supplied with the cooling system), can be switched to either 110/120 volt or 220/240 volt operation.  However, the transformer uses the standard US-style 2-prong plug.
Contact me if you need an adapter plug (
there is no charge
), and specify one of the three types:  1) NZ/AU  (2 slanted prongs) 2) Euro (2 round prongs), or UK (three large prongs).
Even at low speeds settings, the fan will replace a volume of air equal to that of most components many times times per minute.
All cooling system parts connect together using special heavy-duty Molex quick-connect plugs, which allows the parts to be separated for easy wire-routing.
The system comes completely assembled, with all components installed, wired and ready to go!
Specifications
Fan dimensions:
The fan unit is 7-1/4" square, 1-1/2" tall (including the top grill and air-chamber base), and only requires 3/8" of space above for air flow.
Maximum current draw:
.16 amps or 2 watts.  Normal operation (at lower speeds) will draw less current and watts.
Bearing type:
Super quiet, long lasting Fluid Dynamic bearings.
The table below shows specifications for
one 80mm fan,
at several different speeds.
The shaded area on the table indicates suggested fan speeds for this system.
With cabinet cooling, slow (and quiet) are the way to go!
Fan Speed
Full
3/4
2/3
1/2
1/3
1/4
CFM (cubic feet of air per minute)
74
56
49
37
25
18
DB (decibels/ noise level)
22
19
16
13
10
7
Fan RPM (speed)
1350
1012
810
675
405
338
If you would like to see this cooling system's installation instructions, please contact me and I will supply a .PDF file with the contents.
Payment, Shipping
& Warranty
Payment:
You can pay using Paypal, or by using a major credit card, after your purchase.
Shipping:
Within the U.S., shipping is normally by Priority Mail.  For International shipments, I use USPS First Class International.
Import duties, etc.:
International Buyers – Please Note:
Import duties, taxes and charges are
not included
in the item price or shipping charges. These charges are the buyer's responsibility.  Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying.
Returns:
Within the first 30 days after receipt, systems which are in original condition can be returned for a full refund of the purchase price.  Please contact me for shipping address and instructions
.
Warranty:
All systems are covered by a 12 months parts & labor warranty.
YOUR SATISFACTION IS GUARANTEED!
Custom Systems
Please contact me if you have any questions, or if you want to discuss a custom cooling system to fit your special needs:
Click here to ask a question
You can also visit my Ebay store, where you will find systems designed for a number of different cooling needs:
Click here for my store
All text and images on this page (other than those provided by Ebay), copyright © 2007-2017 by DR McKenzie. Rev. 051717